15 W Medically certified switching charger for lead-acid batteries; 24 VDC 0,56 A 3743/24VDC

Mascot 3743 is switching three-step charger with current detection as charge termination for lead-acid batteries. It has a LED indication of charge status and error indication for reverse polarity, short circuit, charging of lower voltage batteries and safety timer run-out.

Step 0: Low current start-up when Vbatt is less than 21V. Error mode if Vbatt stays below 21V after 30 minutes charging.
Step 1: Charging with constant current until battery voltage reach 29,4V.
Step 2: Charging with constant voltage until charging current is less than 0,15A or timer reach 4h.
Step 3: Automatic switch to microprocessor controlled current pulses at safe float voltage level for maximum topping of battery capacity.

Charging control with current detection as charge termination.

All chargers are equipped with exchangeable AC mains plug input connector as well as with IEC 320-C8 input for worldwide applications. DC-cord is equipped with Snap-Lock connector for exchangeable DC-plugs. There is also available the versions with battery clips, push-on connectors and DC-cord with open ends.

Recommended capacities:
24V 0,56A model: 2,8 - 28 Ah

Available options:
Exchangeable AC mains plugs
AC mains cords
Exchangeable Snap-Lock DC-plugs